| Center X |
Enter the value of x to relocate an existing annotation to a new
location. |
| Center Y |
Enter the value of y to relocate an existing annotation to a new
location. |
| Routing Database |
Select the database to use (For example, Pedestrian, Driving) |
| No. of Rings |
Enter the total number rings. By default, 1 ring is created. You can
increse upto maximum 5 rings only. |
| Travel Time |
If Travel Time is chosen then further options are:
- Time Units- The units to return time. The default
is min (minute). Available values are: min(minute), s(second), h(hour).
- Historic Speed Profile- Specifies whether the
routing calculation uses the historic traffic speeds. These speeds are based
on different time-of-day buckets. The data must have historic traffic speeds
included in order to use this feature. The data for each country/region has
the same bucket definitions, where the speeds for these bucket values may
vary. The options are:
- None- The default value. Historic traffic data is not used in
the calculation. Instead an averaged speed value is used.
- AMPeak- Calculate routes with the peak AM speeds. The AMPeak
time bucket is from 07:00 to 10:00hr time of day.
- PMPeak- Calculate routes with the peak PM speeds. The PMPeak
time bucket is from 16:00 to 19:00hr time of day.
- OffPeak- Calculate routes with the off peak (daytime) speeds.
The OffPeak time bucket is from 10:00 to 16:00hr time of day.
- Night- Calculate routes with the nighttime speeds. The Night
time bucket is from 22:00 to 04:00hr time of day.
- Time- Enter time.
|
| Travel Distance |
If Travel Distance is chosen then further options are:
- Distance units- The units to return distance. The
default is m (meter). Available values are: m(meter), km(kilometer),
yd(yard), ft(foot), mi(mile).
- Distance- Enter distance.
|
| Apply |
Tap Apply, to apply changes to annotation properties. |
| Cancel |
Tap Cancel, to cancel and close the properties dialog box. |
